autoLYNX SWAY BAR DISCONNECT – Apex Performance Products

$ 297.00

4.7 (509) In stock

The patented AutoLYNX was designed to make disconnecting the sway bar much faster and easier: No need to fight a stuck link. No need to find perfectly flat ground to connect or reconnect. To disconnect the sway bar, just hop out and turn the knob a quarter turn and then do the other side. Takes less than 10 seconds. It’s easy to turn and that's it. Hop back in and drive. You can do this on relatively un-flat ground up to 4” of articulation. To reconnect, turn the knobs back to the lock position and push the sway bar down until you hear a “click” and that's it. Only one side needs to be pushed down to latch. As you drive, it will automatically latch the other side. Your Jeep can be at full articulation to re-latch the bar. No need to park the bar or clean the mounting pins. No need to find level ground. No need to push and pull under a muddy Jeep. The hardest part is getting out of the Jeepthat’s it! APEX Performance AutoLYNX Sway Bar Disconnect.

FITMENT GUIDEINSTALLATION INSTRUCTIONSSTEERING STOP ADJUSTMENTTROUBLESHOOTING INSTALLATIONNOISE TROUBLESHOOTINGSPORT/SAHARA/WILLYS INSTALLATION NOTES

APEX autoLYNX Sway Bar Disconnect (Pair)

Apex AutoLYNX sway bar disconnect, Page 4

APEX Steering Boost Kit Jeep JL/JT – Pivotal Motorsports

APEX PERFORMANCE 2.0 AutoLYNX Sway Bar Disconnect 8 Stroke

Apex Designs autoLYNX 8 Stroke Sway Bar Disconnect Kit 07-23 Jeep Wrangler JK JL Gladiator JT

autoLYNX Fender Liner Trim

APEX Performance Products, The Apex AutoLYNX make life easy getting on and off the trail. Disconnect and reconnect your sway bar with a simple twist of a knob! 👌

APEX Designs autoLYNX Front Sway Bar Disconnects. If you plan on upgrading to longer shocks than factory supplied, use the 10.5 stroke autoLYNX. • OE

APEX autoLYNX 8 Stroke Front Sway Bar Disconnects for 07-18 Jeep Wrangler JK

Apex Performance Products

autoLYNX SWAY BAR DISCONNECT – Apex Performance Products

APEX Performance Products (@apexdesignsusa) • Instagram photos and videos

APEX Performance Products on Instagram: Why do we choose to run our autoLYNX on Rubicon models? The answer is control… The factory electric disconnect on the Rubicon automatically reconnects at 15mph and

APEX Designs autoLYNX Front Sway Bar Disconnects Kit for '18-'23 Jeep – azoffroadperformance

SKU: X02-03-005 - $6 Recommended for stock ride height or low lift applications where link alignment may be needed., These are not typical soft

autoLYNX WASHER KIT